Electric Thermostats
Who are you?ProductsDocumentationBusiness AreasToolsNewsService & SupportContact
Dial Setting Room Thermostats (Heat)
Programmable and Set-back Thermostats (Heat)
6000 Series Heat/Cool Programmable Room Thermostats
Dial Setting Room Thermostats (Heat/Cool)
Dial Setting Room Thermostats with Auto Changeover
Other Thermostats
Devimat Installation

Devimat Installation
How to install your Devimat
 
 
 
 

You can do most of the job yourself, but Connection to the power supply may ONLY be carried out by an qualified electrician

Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the devimat heating cable mat.
Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws.
Cut a channel approx. 10 mm deep and wide in the wall and the floor, from the thermostat and about 1 m out into the floor. Glue the flex pipe for the sensor into this channel, and seal the end of the pipe with a piece of tape.
Clean the floor thoroughly, removing all dirt and soap residue, then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles.
Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable!
Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result.
Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using selflevelling screed or cover it with a thin layer of tile adhesive.

Did you know...

Did you know...
... the use of an electronic room thermostat with chrono-proportional capability provides closer temperature control plus possible reductions of 10% in both fuel cost and carbon emisions?

Find out more...